Kingy said:
Spiny Norman said:
Kingy said:
Had my first dud print yesterday. Any of the experts here have useful suggestions?
The corners also look pretty average. Check out the Calibration tab right up in that top list and run the Flow Dynamics and Flow Ratio tests.
Also, your filament might suck!
Thanks, Spiny. I haven’t checked out all the options yet(there’s hundreds of them), but the filament has produced nice product before.
I’ll check those out tomorrow.
I’ve just built a waste(poop) conveyor powered by the up and down motion of the crossbar. Each time it goes down enough to reach the bed, it ratchets the conveyor forward a notch or two. It empties into a bin on the floor.


When the crossbar goes down low enough, it pushes down on the upright plunger, which ratchets the conveyor forward a few notches, the lacky band returns the ratchet to the starting position.

