Date: 24/10/2026 22:29:27
From: Kingy
ID: 2442056
Subject: re: 3D Printers

Kingy said:


I’m still learning this stuff.

All of these were printed with the same filament(PLA Rainbow).

The one on the left was printed 8 weeks ago. The ones on the right, today.

Any ideas of what the problem is?

It turns out that I think the problem was damp filament. (It’s been raining here).

I’ve ordered some silica gel to dry the filament and a filament drying compartment, which will fix it, but only temporarily.

The main problem is that the filament on the 4 hose reels are out in the air. There are a few solutions, including buying a few cheap cake boxes off ebay, glueing it to the holder, and chucking some desiccant in them.

Reply Quote View full thread